User guide

J: CCD/CCTV Video Setup for Discontinued Hardware
254 —
revision 143
that the Adapter Type field indicates “Integral Technologies FlashPoint
128”.
6. If the Adapter Type field indicates the correct entry for your FlashPoint
board and you have a FlashPoint Display Drivers diskette that has a version
number newer than what is shown in the Adapter Type field go to step 8.
7. If the Adapter Type field indicates the correct entry for your FlashPoint
board, click [Cancel] then go to Step 5: Verify That the VGA Display
Settings are Correct on page 255.
8. Click [Change...] located to the right of the Adapter Type field. The Change
Display window will be displayed.
9. Do the following if you are using a FlashPoint 128 or FlashPoint Lite 128
board. (You must have a FlashPoint Display Drivers diskette):
• Click [Have Disk...]. The Install from Disk window will appear.
• Insert the FlashPoint Display Drivers diskette into your floppy drive.
• Click [Browse...]. The Open window will appear.
• Navigate into (double-click on) the “winnt40” directory on the driver
diskette.
• Click [Open]. This will return you to the Install from Disk window.
• Click [OK]. A second Change Display window will appear.
• Select “Integral Technologies FlashPoint 128” in the “Display” list.
•Click [OK].
• If a message pertaining to third party drivers appears, just click [Yes] to
proceed.
10. Do the following if you are not using a FlashPoint 128 or FlashPoint Lite
128 board and you have a FlashPoint Display Drivers diskette:
• Click [Have Disk...]. The Install from Disk window will appear.
• Insert the FlashPoint Display Drivers diskette into your floppy drive.
• Click [Browse...]. The Open window will appear.
• Navigate into the “winnt40” directory on the driver diskette.
• Click [Open]. This will return you to the Install from Disk window.
• Click [OK]. A second Change Display window will appear.
• Select “Integral Technologies FlashPoint” in the “Display” list.
•Click [OK].
• If an informational window about third party drivers appears, just click
[Yes] to proceed.
11. Do the following if you are not using a FlashPoint 128 or FlashPoint Lite
128 board and you don’t have a FlashPoint Display Drivers diskette. (You
can use the ET4000 VGA display driver):
• The Change Display window will contain a “Manufacturers” list and a
“Models” list. Select “Tseng Labs” in the Manufacturers list.
• In the Display list of Models list select “Tseng Labs W/32i Compatible
Graphics Adapter” if your FlashPoint board is an ISA board otherwise
select “Tseng Labs W/32p Compatible Graphics Adapter”.
• Click [OK]. A Files Needed window will appear.