User guide

Installation & Setup User Guide
revision 143 — 251
Appendix J: CCD/CCTV Video Setup for Discontinued
Hardware
Configuring Video Hardware and Software
This procedure will verify that your system video capture board and required
Windows drivers are configured properly for live video capture/CCTV video
with one of the following Integral Technologies video capture boards: FlashPoint
ISA, FlashPoint PCI, FlashPoint Lite PCI, FlashPoint 128 and FlashPoint Lite
128. Those with FlashPoint 3D Lite or FlashPoint 3D Plus should refer to
Chapter 4: CCD/CCTV Video Setup. Those with other capture boards should
contact your BEST customer service representative before proceeding. Be sure to
perform Step 1: Check to Make Sure You Have All the Required Video
Hardware through Step 3: Install the FlashPoint Video Capture Board before you
install any Integral Technologies FlashPoint software.
The latest setup software for all of the discontinued Integral Technologies
FlashPoint board models (FlashPoint ISA, FlashPoint PCI, Flashpoint Lite PCI,
FlashPoint 128, FlashPoint Lite 128) is version 3.4. The FlashPoint software is
available for download from Integral’s web site: http://www.integraltech.com/
support/dload.html. However, to ensure proper functioning with B.A.S.I.S., users
should contact BEST first if they want to use a version later than 3.4.
The FlashPoint User’s Manual and accompanying Setup software diskettes are
required for the procedures outlined in this chapter. You may also need your
Windows 2000 CD or a FlashPoint Display Drivers diskette from Integral
Technologies.
Step 1: Check to Make Sure You Have All the Required
Video Hardware
Those with a FlashPoint 3D Lite or FlashPoint 3D Plus video capture board,
refer to Chapter 4: CCD/CCTV Video Setup.
You will need a FlashPoint video capture board. Refer to the “FlashPoint Cables”
chapter of the FlashPoint User’s Manual for the video input cable requirements
of your board.
Find out which model of FlashPoint board you have and how much VGA frame
buffer memory (RAM) it has. It is essential to know these two things for the
steps that follow.
If you’re setting up a capture station you need the following hardware:
• Hitachi VKC-77U camera and power pack (CAM-77U): (Has been
replaced by CAM-CCP-500K.)