User guide

Installation & Setup User Guide
revision 143 — 247
click [Yes]. Otherwise, click [No] and create a new database that follows the
recommended naming scheme.
8. If your database does not contain any data, skip ahead to step 9. If the
following message is displayed, then your database already has data in it.
Click [Yes] to remove all existing data.
9. The Pre-Allocated ID Ranges form is displayed. This allows you to adjust
the amount of pre-allocated IDs for each record type that you wish to “grab”
for the region initially. You can also adjust the “Low Water Mark”, which is
the amount of remaining IDs below which new IDs will automatically be
“grabbed” again. There is normally no need to change these default settings;
however you may wish to adjust the number of Cardholder and Badge IDs
you wish to allocate depending on how many new Cardholders/Badges you