User guide

Installation & Setup User Guide
revision 143 — 197
Verify the backup options that will be used are correct, and then click [OK].
12. A message is displayed indicating the commands attempted and the results.
Make sure that the results say that the commands executed successfully, and
then click [Close].
Restore a DB2 Database
1. Open DB2 Control Center by clicking Start > Programs > IBM DB2 >
General Administration Tools > Control Center.
2. Click on the System in the tree in the right pane that contains the database
you wish to restore. You will be prompted to log in. Enter a username and
password for the database, and then click [OK].
3. Expand the tree in the right pane until the database you wish to restore is
shown. If you set up your database as directed in the Database Backup and
Restoration chapter, your database would be “ACCTRL”.
4. Right-click on the database and select Restore.
5. The Restore Database Wizard opens, and the Step 1: Introduction window
opens. Select the database restore alternative you wish to use, and then click
[Next].
6. The options available in the Restore Database Wizard will change depending
on the restore alternative you selected. Please refer to the DB2
documentation for more information about each alternative and continue
through the Restore Data Wizard.