User guide

13: Database Backup and Restoration
188 —
revision 143
After the backup schedule has been set up, you can run your backup immediately
test to make sure that your backup is set up correctly, rather than waiting until the
first scheduled backup.
1. Open the Windows Control Panel, and then double-click “Scheduled Tasks”.
2. Right-click on the Accesscontrol task, and then select Run.
3. After a short delay, the backup runs.
4. To verify that the backup ran:
a. Start the Windows Backup software. To do this, click the Start button,
and then navigate to Programs > Accessories > System Tools > Back
up.
b. Click the Restore tab.
c. The backup is listed, as shown.