User guide

8: Installing and Configuring WirelessOffice Messaging Software Version 5.0
104 —
revision 143
“Add a Custom Alarm” in the Alarm Configuration Folder chapter in the
System Administration User Guide.)
3. Click the Messages tab.
4. Add an automatic page message. For more information please refer to “Add
an Automatic Page Message” in the Installation & Setup User Guide.
5. Select System Options from the Administration menu.
6. Click [Modify].
7. In the Workstation field in the Linkage Server Host section, specify the
name of the computer that the “LS Linkage Server” service will run on.
• If the wrong server is selected in the Workstation field, the “LS
Linkage Server” service will not be able to be started.
• The Workstation must be the same computer that was specified in File
Messenger in the Primary Server field on the WirelessOffice tab.
8. Click [OK].
9. Confirm that the “LS Linkage Server” service has a Status of “Started” and
a Startup value of “Automatic”. To do this:
a. Click the Windows Start button, then select Settings > Control Panel >
Administrative Tools.
b. Double-click on the Services icon.
c. Scroll through the Service column. The “LS Linkage Server” service
should have a Status of “Started” and a Startup value of “Automatic”.
If it does not:
– To change the Startup value to “Automatic”, select the “LS
Linkage Server” service, right-click on the service and select
Properties from the pop-up menu. Under the General tab, select
“Automatic” from the Startup Type drop-down list, and click
[OK].
– To change the Status to “Started”, click the [Start Service] button in
the Services window.
Note: If the “LS Linkage Server” service fails to start, the wrong server was
selected as the Linkage Server Host. To fix this, repeat steps 4-7, selecting
the Workstation that the “LS Linkage Server” service will run on in step 7.