User guide

Installation & Setup User Guide
revision 143 — 103
Properties from the pop-up menu. Under the General tab, select
Automatic from the Startup Type drop-down list, and click [OK].
– To change the Status to “Started”, select the service that needs to be
changed, then click the [Start Service] button in the Services
window.
B.A.S.I.S. Procedures
Set Up Manual Paging
1. Open System Administration. To do this, click the Windows Start button,
then select Programs > B.A.S.I.S. ET > System Administration.
2. In System Administration, set up a paging device or devices. (To display the
Paging Devices form, select Global Output Devices… from the
Administration menu, then click on the Paging Devices tab. For more
information please refer to “Add a Paging Device” in the Global Output
Devices Folder chapter in the System Administration User Guide.)
3. In System Administration, create a recipient. (To display the Recipients
form, select Global Output Devices… from the Administration menu,
then click on the Recipients tab. For more information please refer to “Add a
Recipient” in the Global Output Devices Folder chapter in the System
Administration User Guide.)
4. Confirm that the “LS Global Output Server” service has a Status of
“Started” and a Startup Type value of “Automatic”. To do this:
a. Click the Windows Start button, then select Settings > Control Panel.
b. Double-click the Administrative Tools icon.
c. Double-click the Services icon.
d. Scroll through the Name column. The “LS Global Output Server”
service should have a Status of “Started” and a Startup value of
“Automatic”. If it does not:
– To change the Startup value to “Automatic” select the “LS Global
Output Server” service, right-click on the service and select
Properties from the pop-up menu. Under the General tab, select
“Automatic” from the Startup Type drop-down list, and click
[OK].
– To change the Status to “Started” select the “LS Global Output
Server” service, then click the [Start Service] button in the Services
window.
Set Up Automatic Paging
1. Before setting up automatic paging, set up manual paging. (For more
information, refer to Set Up Manual Paging on page 103.) This will insure
that the paging devices and recipients that are needed for automatic paging
get set up.
2. In System Administration, create a custom alarm definition. (To display the
Alarm Definitions form, select Alarms… from the Monitoring menu, then
click on the Alarm Definitions tab. For more information please refer to