User Manual
Table Of Contents
- 5400 RPM - SATA Product Manual
- Seagate® Technology Support Services
- 1.0 Introduction
- 2.0 Drive Specifications
- 2.1 Formatted Capacity
- 2.2 Physical organization
- 2.3 Recording and Interface Technology
- 2.4 Physical Characteristics
- 2.5 Seek time
- 2.6 Start/stop times
- 2.7 Power Specifications
- 2.8 Environmental Specifications
- 2.9 Acoustics
- 2.10 Electromagnetic Immunity
- 2.11 Reliability
- 2.12 Agency and Safety Certifications
- 2.13 Safety certification
- 2.14 Environmental protection
- 2.15 Corrosive Environment
- 3.0 Configuring and Mounting the Drive
- 4.0 Serial ATA (SATA) Interface
Seagate FireCuda Product Manual, Rev. H 24
Configuring and Mounting
Figure 7 Mounting Dimensions (for 1-disk models) (alternate basedeck)
100.350
+
-
0.200
0.250
69.850 ± 0.250
2.499 ± 1.270
7.949 ± 1.270
(16.520)
(22.450)
(90.600)
(14.000)
2X (3.000)
7.000 0.200
2X M3 X 0.5-6H
MOUNTING HOLES: BOTH SIDES
4MM MIN. SCREW DEPTH FROM
M3 PADS. NO THRU.
3.5+.075-.3X90
(3.500)
BASE
BOTH SIDES
4 X M3 X 0.5-6H
2.5MM MIN FULL THREAD. NO THRU
3.5 +.075 -.3 X90
RECOMMENDED
TEMPERATURE
MEASUREMENT
LOCATION