User Manual
Table Of Contents
- 5400 RPM - SATA Product Manual
- Seagate® Technology Support Services
- 1.0 Introduction
- 2.0 Drive Specifications
- 2.1 Formatted Capacity
- 2.2 Physical organization
- 2.3 Recording and Interface Technology
- 2.4 Physical Characteristics
- 2.5 Seek time
- 2.6 Start/stop times
- 2.7 Power Specifications
- 2.8 Environmental Specifications
- 2.9 Acoustics
- 2.10 Electromagnetic Immunity
- 2.11 Reliability
- 2.12 Agency and Safety Certifications
- 2.13 Safety certification
- 2.14 Environmental protection
- 2.15 Corrosive Environment
- 3.0 Configuring and Mounting the Drive
- 4.0 Serial ATA (SATA) Interface
Seagate FireCuda Product Manual, Rev. H 12
Drive Specifications
Figure 2 Typical 2D - 5V Startup and Operation Current Profile
2.7.2 Conducted noise
Input noise ripple is measured at the host system power supply across an equivalent 15-ohm resistive load on the +5 volt line.
• Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave injected noise at up to 20 MHz.
2.7.3 Supply Voltage
Note
Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write current.
Allowable voltage 5V ± 5%
Allowable noise/ripple 100 p-p max, 0-20 MHz
Allowable supply rise time <100 ms