Specifications

2-10 Sun StorEdge A1000 and A3x00/A3500FC Best Practices Guide • November 2002
2.6 Cluster, Multi-Initiator, and SCSI Daisy
Chaining Configurations
This section contains the following topics:
■ Section 2.6.1, “Cluster Information” on page 2-10
■ Section 2.6.2, “Multi-Initiator Information” on page 2-11
■ Section 2.6.3, “SCSI Daisy Chaining Information” on page 2-11
2.6.1 Cluster Information
Refer to the Sun StorEdge A3500/A3500FC Hardware Configuration Guide for
instructions about cabling and setting up the SCSI ID and/or the FC loop ID.
The Sun Cluster home page is located on the following web site:
http://suncluster.eng/index.html
For detailed cluster configuration information, refer to the Sun Enterprise Cluster
System Hardware Site Preparation, Planning, and Installation Guide. You can find this
document on the following web site:
http://suncluster.eng.sun.com/engineering
For more details about controller replacement and restoring in a cluster
environment, refer to the Sun Cluster 3.0 Hardware Guide, “How to Replace a Failed
StorEdge A3500 Controller or Restore an Offline StorEdge A3500 Controller”. Sun
Cluster 3.0 documents are available on the following web site:
http://suncluster.eng/products/SC3.0
Specific Sun Cluster documents and relevant chapters within these documents are:
■ Sun Cluster 2.2—Sun Enterprise Cluster 3000/4000/5000/6000/10000 Hardware
Service Manual, 805-6512, chapter 3 “Hardware Troubleshooting and chapter 9
“Major Subassembly Replacement”.
■ Sun Cluster 3.0—Sun Cluster 3.0 Hardware Guide, 806-1420, chapter 7 “Installing,
Configuring, and Maintaining a Sun StorEdge Disk Array”.