Specifications

Index-4 Sun StorEdge A1000 and A3x00/A3500FC Best Practices Guide • November 2002
O
obtaining
Debug Guide, 1–5
RAID Manager, 1–4
serial cable, 1–5
obtrusive controller, 6–2
onboard SOC+, 2–12
OneStop Sun Storage Products web site, 1–4
P
parity check settings, 3–10
parityck command, 3–11
patch information, 5–17
PFA, 3–3
phantom
controllers under RAID Manager 6.22, 6–14
power
cables, 2–2
sequencer, 2–3
sequencer configuration for 3x15, 2–3
sequencer configuration for new installation, 2–
3
sequencer replacement, 5–11
power consumption specifications, A–5
predictive failure analysis, 3–3
product name matrix, A–7
Q
QAST web site, 1–4
quorum device, 4–14
R
RAID
module configuration, 3–3
phantom controllers, 6–14
reconstruction rate, 3–7
use of RAID levels, 3–6
RAID Manager
6.0/6.1 not supported, 1–5
bootability support, A–4
commands, A–2
installation and configuration, 3–1
issues whenupgrading from RAID Manager 6 to
6.11 or 6.22, 4–2
upgrade, 5–18
upgrading to 6.22, 1–5, 3–2
white paper, 1–6
rdac_disks command, 6–15
rdacutil -U command, 5–8
rdacutil -u command, 5–8
reason controllers should be failed, 6–2
reconstruction rate of RAIDs, 3–7
recovering from a power supply thermal
shutdown, 5–14
reference, A–1
replacing
battery unit, 5–13
controller card, 5–12
disk drives, 5–14
disk tray, 5–14
failed controller, 6–4
FRUs, 5–10
HBA, 5–10
hub, 5–12
interconnect cables, 5–11
midplanes, 5–15
power cords, 5–11
power sequencer, 5–11
reset configuration, 5–16
rmlog.log fan failure message, 5–2
S
scripts, A–2
scripts and man pages, A–2
SCSI
A3x00 SCSI Lite, 2–9
cables, 2–3
common point of failure with cables, 5–6
configurations, 2–10
crossing SCSI cables, 2–4
daisy chaining information, 2–11
disabled wide SCSI mode, 5–9
ID, 2–4
ID jumper settings, 5–7
reducing sync transfer rate, 5–9
SCSI bus length calculation, 2–4
SCSI bus maximum bus length, 2–3
SCSI ID conflict, 2–5
SCSI to FC-AL upgrade, 2–14
termination power jumpers, 5–7