Technical information

5. Remove the PCI bridge card (CRU) to access the PCI backplane.
6. Disconnect the other end of the cable from the PCI backplane. (See Figure 4-56.)
Figure 4-56. Disconnecting the SCSI Data Cable from the PCI Backplane
7. Repeat steps 3 through 6 for the second PCI bridge card)
4.5.15 Installing U450 16-port Support Bracket (AK-000331)
1. Open the cabinet rear door.
CAUTION: Place some sheets of paper (or other material) over the PCI card cage to prevent any
hardware from falling in.
2. Install clip nuts in holes #22 and #24 (counting down from the top) on the vertical rails on each side of
the chassis. (See Figure 4-57.)