Technical information

6. At the cabinet front, insert PSU0 and PSU1 disk power supplies back into the top disk shelf.
7. WAIT for the disk drives to mirror up (This may take several hours).
8. Pull PSU0 and PSU1 disk power supplies from the bottom disk shelf.
9. At the cabinet rear, unscrew the AW-001036 connector ("P1") from the bottom disk shelf and screw in
the new AW-001036 connector.
10. Unplug the AW-001036 from the other end of the Molex connector and reconnect the new AW-001036
cable.
11. At the cabinet front, insert PSU0 and PSU1 disk power supplies back into the bottom disk shelf.
4.5.11. Disk Shelf SCSI Data Cable (AW-001034)
1. Shut down the system from the system console.
2. Open the cabinet front door and turn off both main power switches. (See Figure 4-1)
3. Open the cabinet rear door.
4. Disconnect the failed disk shelf SCSI data cable (AW-001034) from the disk shelf (rear). (See Figure 4-
45.)
Figure 4-45. Disconnecting the SCSI Data Cable from the Disk Shelf (rear)
5. Open the cabinet front door.