Datasheet

Medalist Pro Product Manual, Rev. D 27
6.5 Mechanical specifications
The following nominal dimensions are exclusive of the decorative front panel accessory. However, dimensions
of the front panel are shown in figure below. Refer to Figures 6, 7, and 8 for detailed mounting configuration
dimensions. See Section 8.4, “Drive mounting.”
Figure 6. Mounting configuration dimensions for “N” models
Height: 1.007 in 26.9 mm
Width: 4.000 in 101.6 mm
Depth: 5.754 in 146.15 mm
Weight: 1.5 pounds 0.68 kilograms
Inches
A
B
C
D
E
F
G
H
J
K
L
M
N
P
R
S
146.15
101.6
25.6
60.00
28.45
101.60
6.35
44.45
95.25
41.28
3.63
6.60
1.55
10.29
57.53
59.69
5.754
4.000
1.007
2.362
1.120
4.000
.250
1.750
3.750
1.625
0.143
0.260
0.061
0.405
2.265
2.350
± .026
± .015
± .013
± .010
± .020
± .010
+ .010
– .005
± .010
± .010
± .020
± .66
± .38
± .33
± .25
± .51
± .25
+ .25
– .12
± .25
± .25
± .51
Dimension Table
Millimeters
[7]
Mounting holes three on each side, 6-32 UNC. Max
screw length into side of drive 0.15 in. (3.81 mm). Screw tightening
torque 6.0 in-lb (.675 NM) max with minimum thread engagement of
0.12 in. (3.05 mm).
Mounting holes four on bottom, 6-32 UNC. Max screw length into
bottom of drive 0.15 in. (3.81 mm). Screw tightening torque 6.0 in-lb
(.675 NM) max with minimum thread engagement of 0.12 in. (3.05 mm).
Power and interface connectors can extend past the “A” dimension
by 0.040 in. (1.02 mm).
Centerline of pad for Pin 1 of power connector.
Centerline of pad for Pin 1 of J6.
Centerline of pad for Pin 1 of J2. Dimensions indicated are for
reference only.
Dimensions to Pin 1 of each connector are nominal values.
To pin ends on J6. Pin ends on J6 are nominally flush with
end of drive.
Notes:
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
B
J
[4] L
H
M [6]
[6] N
J2
J6 LED
K
S [8]
[2]
R
P [5]
[7]
A [3]
F
D
[1]
[3]
G
C
E