Technical data

79
EIDE CD-ROM Drive (CDSK177)
The following figure shows the back of the EIDE CD-ROM drive for the TDZ-425 RAX system.
Install jumpers as shown.
Mode Select 1
Audio Connector
Power
Connector
IDE Connector
Mode Select 2
The power connector uses power supply cable P6 from the power supply. Refer to Chapter 10,
“Power Supply and Fans,” for the cable pinout.
The audio connector uses MCBL122A and connects to J22 on the system board. Refer to
Chapter 6 for the cable pinout.
The IDE connector uses cable MCBL121A and connects to the Primary IDE Bus on the
MSMT378 system board. Refer to Chapter 6 for the cable pinout.
The Mode Select 1 header is jumpered “master” as shown. Settings for the mode select header
are printed on the CD-ROM drive.