Manualshelf

Technical data

ManualsBrandsSeagate ManualsHome building and DecorST34501N
81828384858687888990
77
CDSK123, CDSK164, CDSK165, CDSK166, CDSK167 (4 GB)
The following figure shows the jumper connectors J6 and J2 on the Seagate 4 GB and 9 GB disk
drives. SCSI ID selection uses the ID1, ID2, and ID4 jumpers on connector J6. To disable SCSI
termination, remove the TE jumper from connector J2.
TE
ID1
ID2
ID4
SCSI
Connector
Pin 1
Power
Connector
oooooooo
oooooooo
J6
J2
Floppy Disk Drive (CDSK146)
The following figure shows the cable connectors on the back of the floppy disk drive.
Floppy
Connector
Power
Connector
The power connector uses power supply cable P9 from the power supply. Refer to Chapter 10,
“Power Supply and Fans,” for the cable pinout.
The floppy connector uses cable MCBLZ380 and connects to J30 on the system board. Refer to
Chapter 5 or 6 for the cable pinout.