Technical data

76
CDSK094 (2 GB)
The following figure shows the jumper connectors J6 and J2 on the Seagate 2 GB disk drive. SCSI ID
selection uses the ID1, ID2, and ID4 jumpers on connector J6. To disable SCSI termination, remove
the TE jumper from connector J2.
TE
ID1
ID2
ID4
SCSI
Connector
Pin 1
Power
Connector
oooooooo
oooooooo
J6
J2
TP
CDSK098 (4 GB)
The following figure shows the jumper connector J5 and SCSI terminator sockets on the Conner 4 GB
disk drive. Connectors 0E1 through 0E3 are also available on a jumper block near the SCSI
terminator sockets; do not install jumpers on these connectors. To enable SCSI termination, install
the proper resistors into both terminator sockets. To disable SCSI termination, remove both resistors
from the sockets.
SCSI Terminator
Sockets
J5
0E1
0E2
0E3