Technical data

11
Internal Bay Disk Drives
To replace drives in the internal bay:
1. Disconnect the SCSI cable and power cable from the disk drive as shown in the following figure.
2. Disconnect the fan cable. Note the location where the fan cable connects to the system board.
3. Remove the two screws that secure the internal bay to the base unit.
4. Slide the internal bay toward the front until it disengages; then lift it out of the system.
5. Remove the screws that secure the disk drive to the internal bay. Two screws are on top, as
shown, and two are on the bottom.
6. Remove the disk drive from the bay.
7. Set the SCSI ID on the new disk drive to the same SCSI ID as on the old disk drive.
8. Attach the new disk drive to the internal bay.
9. Place the internal bay into the base unit, and slide it toward the rear until it engages.
10. Attach the bay to the base unit.
11. Connect the SCSI cable and power cable to the disk drive.
12. Connect the fan cable to the system board.
13. Close the base unit.
Screws
Internal
Bay
Power
Cable
Screws
SCSI
Cable
Fan
Cable