Manualshelf

Technical data

ManualsBrandsSeagate ManualsHome building and DecorST34501N
11121314151617181920
10
5. Remove the slot filler by removing screws as shown in the following figure; then remove the four
screws securing the disk drive to the tray.
6. Set the SCSI ID on the new disk drive to the same SCSI ID as on the old disk drive.
7. Attach the new disk drive to the tray and slide it into the vertical bay.
8. Secure the drive to the bay.
9. Connect the SCSI cable and power cable to the disk drive.
10. Replace the disk drive fan and connect the fan power cable.
11. Close the base unit.
Drive Tray
Slot Filler
Screws
Screws (Two
each side)