User manual

iSCSI GbE to SAS/SATA II RAID Subsystem
User Manual
63
Step 2: Create VD (Virtual disk).
To create a data user volume, please follow these steps.
1. Select “/ Volume configuration / Virtual disk”.
2. Click “
”.
3. Input a VD name, choose a RG Name and enter a size for this VD; decide the
stripe height, block size, read / write mode, bg rate, and set priority, finally
click “
”.
4. Done. A VD has been created.
5. Repeat steps 1 to 4 to create another VD.
Two VDs, “VD-R5-1” and “VD-R5-2”, were created from RG “RG-R5”. The size of “VD-
R5-1” is 50GB, and the size of “VD-R5-2” is 64GB. There is no LUN attached.
Step 3: Attach LUN to VD.
There are 2 methods to attach LUN to VD.
1. In “/ Volume configuration / Virtual disk”, check the gray button next to
the VD number; click “Attach LUN”.
2. In “/ Volume configuration / Logical unit”, click “
”.