User manual

iSCSI GbE to SAS/SATA II RAID Subsystem
18
User Manual
2.5 Connecting the iSCSI RAID Subsystem to the Network
To connect the iSCSI unit to the network, insert the network cable that came with the
unit into the network port (LAN1) at the back of iSCSI unit. Insert the other end into a
Gigabit BASE-T Ethernet connection on your network hub or switch. You may connect
the other network ports if needed.
For remote management of iSCSI RAID subsystem, use another network cable to
connect the R-Link port to your network.
2.6 Powering On
1. Plug in all the power cords into the AC Power Input Socket located at the rear of
the subsystem.
2. Press Power Switch 1 and 2 to turn on the subsystem.
3. The Power LED on the front Panel will turn green.