User guide

Configuring Network Settings | 75
800-19403 - A - 12/2014
Configuring Email Settings
To configure email notifications
1. Go to Main Menu > Setting > Network > Email.
2. On the Email page, select the Enable check box to enable email notifications for alarm
events.
3. Configure the following settings:
• SMTP Server Enter the SMTP server address of the sender’s email account.
•Port The default TCP/IP port used for SMTP is 25.
• Anonymous Select check box to hide the sender’s address in sent email.
•User Name Enter the user name of the sender’s email account.
• Password Enter the password of the sender’s email account.
• Receiver Enter the email address where you want to send the notification.
You can enter up to three email addresses.
•Sender Enter the sender’s email address.
•Title Enter the email subject.
•Attachment Select check box to enable sending an attachment with the email.
• Encrypt Type Select an encryption type: None, SSL, or TLS.
•Event Interval This is the interval for sending emails. Enter a time between 0 and
3600 seconds. 0 means that there is no interval.
• Health Enable Select check box to enable a health check. The system sends a test
email to check the connection.
•Interval This is the interval the DVR waits before sending out email
notifications after an event is detected. Enter a time between 0 and
1440 minutes. 0 means that there is no interval.