User`s manual

180
Figure 7-30
7.9.2 Network
7.9.2.1 TCP/IP
The TCP/IP interface is shown as in Figure 7-31.
Figure 7-31
Please refer to the following sheet for detailed information.
Parameter
Function
Multiple-address
mode
eth0 and eth1 operate separately. You can use the services
such as HTTP, RTP service via etho0 or the eth1. Usually you
need to set one default card (default setup is etho) to request
the auto network service form the device-end such as DHCP,
email, FTP and etc. In multiple-address mode, system network
status is shown as offline once one card is offline.
Network
In this mode, device uses bond0 to communicate with the
external devices. You can focus on one host IP address. At the