User`s manual

146
5.12 Basic Setups
Set NVR basic setup, device setup and other setups.
5.12.1 General
From Main menu->Setting->General, you can go to the general interface. See Figure 5-104.
 System time: Here is for you to set system time
 Date format: There are three types: YYYYY-MM-DD: MM-DD-YYYYY or DD-MM-YYYY.
 Date separator: There are three denotations to separate date: dot, beeline and solidus.
 DST: Here you can set DST time and date. Please enable DST function and then click set
button. You can see an interface is shown as in Figure 5-105. Here you can set start time
and end time by setting corresponding week setup. In Figure 5-105, enable date button, you
can see an interface is shown as in Figure 5-106. Here you can set start time and end time by
setting corresponding date setup.
 Time format: There are two types: 24-hour mode or 12-hour mode.
Note:
Since system time is very important, do not modify time casually unless there is a must!
Before your time modification, please stop record operation first!
After completing all the setups please click save button, system goes back to the previous menu.
Figure 5-104
Figure 5-105