User`s manual

135
4) Now you can boot up the proxy server. When you see the network status is Y, it means your
registration is OK. You can view the proxy server when the device is online.
Important
The server IP address can also be domain. But you need to register a domain name before you
run proxy device server.
5.10.2.14 WIFI AP
Please note the WIFI AP is for NVR31-W series product only.
Before you use the WIFI AP function, please set network camera mode as wireless network
Ethernet by default and enable WIFI function.
Network settings interface of 31-W series product is shown as below. See Figure 5-87.
Figure 5-87
Double click WIFI AP item, the WIFI AP interface is shown as below. See Figure 5-88.
 Basic setting: It is to set wireless router information. It includes SSID, encryption mode and
password. The default setup is
 SSID: NVR_WIFI
 Authentication mode: WPA2-PSK
 Password: 123456789.
 Save: Click save button to save current customized setup. System needs to restart WIFI AP
module to activate new setup. It may take forty to fifty seconds. During the restart process,
there is corresponding dialogue box for you reference.
 WPS: WPS button is to search and match WIFI AP SSID when the there is no corresponding
network camera information. In Figure 5-88, click WPS button, and then click the WPS button
of the network within the 2 minutes. The net indicator light of the network becomes green and
flashing. After 30 or 40 seconds, the NVR can add the network camera to a channel.
 Default: The Default button is to restore WIFI AP default setup. The restart process may take
forty to fifty seconds. Please note the restart process has no dialogue box. If you can not click