User`s manual

110
folder if you are selecting a file. System pops up a dialogue box if there is no configuration file
under current folder. After successfully import, system needs to reboot to activate new setup.
 Format: Click Format button, system pops up a dialogue box for you to confirm current
operation. System begins format process after you click the OK button.
Note:
 System can not open config backup interface again if there is backup operation in the
process.
 System refreshes device when you go to the config backup every time and set current
directory as the root directory of the peripheral device.
 If you go to the configuration backup interface first and then insert the peripheral device,
please click Refresh button to see the newly added device.
5.9 Alarm
5.9.1 Detect Alarm
5.9.1.1 Motion Detect Alarm
In the main menu, from Setting to Detect, you can see motion detect interface. See Figure
5-50.There is three detection types: motion detection, video loss, camera masking.
 The video loss has no detection region and sensitivity setup and camera masking has no
detection region setup.
 You can see motion detect icon if current channel has enabled motion detect alarm.
 You can drag you mouse to set motion detect region without Fn button. Please click OK
button to save current region setup. Right click mouse to exit current interface.
 Event type: From the dropdown list you can select motion detection type.
 Channel: Select a channel from the dropdown list to set motion detect function.
 Enable: Check the box here to enable motion detect function.
 Region: Click select button, the interface is shown as in Figure 5-51. Here you can set motion
detection zone. There are 396(PAL)/330(NTSC) small zones. The green zone is current
cursor position. Grey zone is the motion detection zone. Black zone is the disarmed zone.
You can click Fn button to switch between the arm mode and disarm mode. In arm mode,
you can click the direction buttons to move the green rectangle to set the motion detection
zone. After you completed the setup, please click ENTER button to exit current setup. Do
remember click save button to save current setup. If you click ESC button to exit the region
setup interface system will not save your zone setup.
 Sensitivity: System supports 6 levels. The sixth level has the highest sensitivity.
 Period: Click set button, you can see an interface is shown as in Figure 5-53. Here you can
set for business day and non-business day. In Figure 5-53, click set button, you can see an
interface is shown as in Figure 5-54. Here you can set your own setup for business day and
non-business day.
 Alarm output: when an alarm occurs, system enables peripheral alarm devices.
 Latch: when motion detection complete, system auto delays detecting for a specified time.
The value ranges from 1-300(Unit: second)
 Show message: System can pop up a message to alarm you in the local host screen if you
enabled this function.