User`s manual

Figure 5-30

Activate Pattern Function

In Figure 5-27, input mode value in the No. blank, and click pattern button.

Auto Scan Setup

In Figure 5-28, click border button. The interface is shown as in Figure 5-31.

Please go to Figure 5-24, use direction arrows to select camera left limit

Then please go to Figure 5-31 and click left limit button

Repeat the above procedures to set right limit.

Figure 5-31

Activate Auto Scan

In Figure 5-27, click “Auto Scan” button, the system begins auto scan. Correspondingly, the auto

scan button becomes Stop button. Click stop button to terminate scan operation.

Flip

In Figure 5-27, click page switch button, you can see an interface is shown as below. See Figure

5-32. Here you can set auxiliary function. The aux value has relation ship with the Aux button of

the decoder.

Click page switch button again, system goes back to Figure 5-24.