User`s manual

Figure 5-23

Select Pan/Tilt/Zoom, the PTZ setup is shown as in Figure 5-24.

Please note the commend name is grey once device does not support this function.

Double click the title to hide the PTZ menu interface.

Here you can control PTZ direction, speed, zoom, focus, iris, preset, tour, scan, pattern aux

function, light and wiper, rotation and etc.

Speed is to control PTZ movement speed. The value ranges from 1 to 8.The speed 8 is faster

than speed 1. You can use the remote control to click the small keyboard to set.

You can click and of the zoom, focus and iris to zoom in/out, definition and brightness.

The PTZ rotation supports 8 directions.

Figure 5-24

In the middle of the eight direction arrows, there is a 3D intelligent positioning key. See Figure

5-25.X Please make sure your protocol supports this function and you need to use mouse to

control.

Click this key, system goes back to the single screen mode. Drag the mouse in the screen to

adjust section size. The dragged zone supports 4X to 16X speeds. Drag the mouse from top to

the bottom to zoom in. Drag the mouse from bottom to up to zoom out. It can realize PTZ

automatically. The smaller zone you dragged, the higher the speed.

Figure 5-25

Here is a sheet for you reference.

Name

Function

key

function

Function

key

function

Zoom

Near

Far