User manual

25960H H.264 DVR User Manual
SECTION 3: SYSTEM SETUP
Table 10. Menu Items in Device Setup Screen
Item Description
ALARM OUT
Set the sensor, motion, and video loss for each alarm.
ALARM OUT: 1 only.
ALARM DURATION: Set the alarm dwell time. (5 ~ 60 seconds or innite (continuous)).
CONTROLLER AND PTZ To control the PTZ functions of the camera, connect the PTZ controller to the RS-485 port on the back of the chassis with
CAT 5 (or equivalent) cable. Setup the CONTROLLER AND PTZ submenu SPEED and ID to match the controller and camera
conguration.
CHANNEL: Channel connected to a PTZ device
CAMERA: Set the PTZ protocol for the camera
SPEED: Baud rate: 19200, 14400, 9600, 4800, 2400
ID: 0 ~ 63
SPOT OUT
Enable/disable display of the channel when an event is active.
SPOT ON EVENT: Enable/disable display of the channel when an event is active.
SPOT EVENT DWELL TIME: Set the dwell time for the event activated channel (1 ~ 10 sec).
SEQUENCE: Enable/disable sequential display of spot channel(s) in full screen. If ON, the spot channel is displayed.
SEQUENCE-DWELL TIME: Set the dwell time for the spot channel display (1 ~ 10 sec).
SPOT CHANNEL: Select a channel for spot monitoring using the mouse or the control button on the remote control and
press OK
button.
CHANNEL Select specied channel for motion zone setup.