User manual
18
SECTION 3: SYSTEM SETUP
SECTION 3
System Setup
3.1 Starting the system for the rst time
When booting the system for the rst time, the following messages appear. After the initialization sequence completes, select your
preferred language and set the date and time.
When the Set date and time window opens, use the drop down lists to select the TIME ZONE and DAYLIGHT SAVINGS time
preference. Check the box show set the current cate and time, if needed, then click Finish. The date and time setting is used to
timestamp recordings.
NOTE
If the DVR will be networked with access to the internet, you can congure an it to automatically acquire date and time settings
from an NTP (network time protocol) server. See the System conguration settings later in this manual.