User manual
107960H H.264 DVR User Manual
SECTION 10: BLACKHAWK FOR MAC
SECTION 10
Blackhawk for Mac
™
BlackHawk for MAC™, the network-based administrative interface to the DVR, is used with an Apple® Mac™ OS X™ computer to
monitor and control the DVR across a network. It can be used to view live video, congure the DVR SETUP menus, and search for and
watch recorded video. BlackHawk for Mac™ can display up to 16 video channels (live or recorded video) simultaneously.
System requirements
To install and use the BlackHawk for MAC application, your Mac™ computer must have at least:
• Operating system: OS X 10.6 and above
• CPU: Intel® Core™2 Duo processors
• RAM: 2GB
• VGA: NVIDIA® or AMD ATI™ graphics interface
You can acquire BlackHawk for Mac through the Apple® App store.
10.1 Getting started
To connect to your DVR, the DVR must be congured and connected to a network. The URL (internet address) to use with BlackHawk
for MAC to connect to the DVR depends what network(s) your Apple® Mac™ computer and DVR are connected to. You can
determine the network settings of your computer and DVR using the following procedures.
10.1.1 Finding the DVR network settings
To use BlackHawk, the DVR must rst be congured and connected to a network. The URL (internet address) of the DVR depends
on the path used to connect to it. If your computer is networked on the same local network as the DVR you are accessing, the URL
is the IP address shown in the DVR System Information window. In the example shown below, the URL is the IP ADDRESS:
192.168.75.79.
MODEL NAME BLK-DH3016D
SOFTWARE VERSION Ver 3.8.1_20130911
STORAGE SIZE 435 GB
NETWORK TYPE STATIC
IP ADDRESS 192.168.75.79
MAC ADDRESS 00:02:69:FF:F2:1B
DDNS STATUS Not Ready
DVR ID DVR
REMOTE CONTROLLER ID 0
OK