Specifications

Hard Disk Drive Tray – HDDT I/O Board
12/01 Application ModuleX Service 91
Honeywell
5.12 HDDT I/O Board
Description
The HDDT I/O board interfaces with the Hard Disk Drive Tray through
the module backplane.
The coprocessor SCSI (disk drive) interface normally stops at connector
J1.
If an optional DAT tape or CD-ROM device exists on your A
X
M, one
end of the daisy-chain device interface cable connects to J1 of the HDDT
I/O board. The device at the far end of this cable must be pinned to
provide the SCSI interface termination.
If neither of the optional devices (DAT/CD-ROM) exists, an external
terminator must be installed on J1 as illustrated.
40039
BAR CODE
J1
Cable to Optional
DAT/CD-ROM Devices
SCSI Interface
Terminator Assembly
or
ASSY NO.
51304913-200
REV B
HDDT-I/O