Specifications

Hardware Description of Coprocessor – WSI2 Board Description
12/01 Application ModuleX Service 49
Honeywell
License key
Honeywell provides the appropriate Kinet license key (correlated to the
coprocessor hardware identification number) to the customer with the
Kinet software at the time of shipment. The customer must enter this
provided license key into the Kinet software configuration data.
Replacement of a WSI2 board assembly due to failure (or any other
reason) also changes the hardware identification number. This makes the
existing Kinet license key (originally provided) unusable and a new
Kinet license key must be obtained when the WSI2 board is changed.
The replacement Kinet license key is obtained in the following manner.
Table 4-1 Procedure to Obtain a Replacement Kinet License Key.
Step Action
1
Install the new WSI2 board assembly as outlined in the replacement
procedure provided later in this section.
2
Power on the node and allow the coprocessor to complete its software
boot.
3
Sign on as a user.
This can be accomplished from any HP-UX compatible
deviceonthePIN(WorkstationorU
X
S) or the coprocessor
console (terminal).
4
Enter the command “/etc/lanscan”.
The last 12 characters after “0x” under Station Address is the new
coprocessor hardware identification number.
5
Having obtained the new hardware identification number, call the
Honeywell Technical Assistance Center (TAC) using telephone number
800-822- 7673.
Inform them that you have changed your Application
Module
X
coprocessor hardware and give them the new
hardware identification number.
6
Honeywell will in turn, provide a new Kinet license key
which must be entered into the Kinet software configuration
data of your system. Reference >>A
X
M System
Administration manual, Installing and Updating Software
(Section 5).