Specifications

DAT DRIVE – DAT Drive Physical Configuration and Cabling
12/01 Application ModuleX Service 119
Honeywell
DAT SCSI
interface
termination
The termination for the coprocessor SCSI bus must be provided by the
device at the end of the cable when external peripherals are connected to
the coprocessor. The DAT drive will always be at the end of the SCSI
cable if a DAT exists.
The terminator assemblies that provide this function within the DAT
drive are mounted immediately above the SCSI interface cable
connection. See the identified terminator assemblies on the following
diagram.
A power jumper at the bottom right is required to provide power for the
terminator assemblies. See the terminator power jumper in the diagram.
These SCSI interface terminators and power jumper must be checked,
and added if necessary, when installing a DAT drive as a new option or a
replacement drive.
40050
Option Switches Located
on Bottom
ON
12345678
(All Switches On)
Terminators
(Plugged in Behind Ribbon Connector)
PWR SCSI 2
SCSI 1 SCSI 0 NC
Power Harness
to 5-Slot
Backplane (J9)
51304836-100
Terminator
Power Jumper
51196257-100
51304837-100
Jumper
Sets
Address=1
TERM