Specifications

TAC Access to Coprocessor – Modem Connection
112 Application ModuleX Service 12/01
Honeywell
Table 7-3 Modem Connection Procedure
Step Action
1
Make sure the modem is properly configured (switches and internal configuration registers).
2
Connect one end of the modem interface cable to the modem.
3
Connect the other end of the modem interface cable to the WSI2 I/O board for serial Serial
Port 1 (connector J1).
You will have to disconnect the coprocessor console terminal cable from this jack if the
terminal is currently connected.
4
Make sure the telephone connection to the modem is properly made.
5
Ensure modem power is on.
6
The communications link hardware is ready for making the telephone connection and
subsequent sign-on by TAC.