Specifications

Coprocessor Console – Coprocessor Console Terminal Connection
104 Application ModuleX Service 12/01
Honeywell
Note: The cable connection to the U
X
S is different depending on if it is Release
100 or 200 hardware. The U
X
S-100 connection is to the WSI I/O board J2
(normally used for printer). The U
X
S-200 connection is to the WSI2 I/O board J1
(normally used for U
X
S coprocessor console terminal).
The following table defines the different cable types available for
connecting coprocessor terminals.
Table 6-2 Cable/Connector Definition for Connecting Console Terminals.
Applicable Terminal Devices Terminal Connector Cable Part Number
HP 712/60 Workstation RS-232 51305069-100
9pin(F)to9pin(F)
U
X
S-100 WSI I/O board (J2) 51305069-100
9pin(F)to9pin(F)
U
X
S-200 WSI2 I/O board (J1) 51305069-100
9pin(F)to9pin(F)
Other VT-100 compatible devices
with 9 pin RS-232 connector.
Serial port 51305069-100
9pin(F)to9pin(F)
Other VT-100 compatible devices
with 25 pin RS-232 connector. *
Serial port 51196218-300
9pin(F)to25pin(M)
* This cable is not supplied with the A
X
M. It is available by separate order.