Specifications

Coprocessor Console – Coprocessor Console Terminal Connection
12/01 Application ModuleX Service 103
Honeywell
Table 6-1 Terminal Connection Procedure
Step Action
1
Make sure the terminal is properly configured (switches/jumpers/etc.).
2
Connect the direct connect terminal interface cable to the terminal. See the diagram
following this table for the proper connection (depends on which device you are using as the
console terminal).
3
Connect the terminal interface cable to the WSI2 I/O board connector for Serial Port 1
(connector J1).
You must disconnect the modem cable from J1 if a modem is currently connected to the A
X
M
coprocessor.
4
Make sure the terminal is powered on.
5
If you are using a PC as the coprocessor console, invoke the emulation software and
configure it for the following characteristics:
• 9600 bits/second
• 8 bits/character
• no parity
6
The procedure for using a VT-100 compatible terminal (simple terminal, Personal Computer,
HP 712/60 workstation, or U
X
S) as a coprocessor console is provided in the Application
Module
X
System Administration manual. Reference: >>A
X
M System Administration manual,
A
X
M Setup
(Section 2.3).
7
Establish communications using the terminal keyboard.
8 The activities that require the coprocessor console terminal are documented in the A
X
M
System Administration manual. Reference: >>A
X
M System Administration manual, A
X
M
Setup(Section2.3).
The following diagram illustrates how the different terminals would be
connected as a console.
40040
WSI2 I/O
Coprocessor
WSI2
Terminal
Interface
Cable
VT-100
Compatible
Terminal
OR
HP 712/60
Work Station
Personal
Computer
US
X
J1
RS-232
Port
Serial
Port
RS-232
Port
Serial
Port