Technical data

9
2. Internal Storage Devices
To remove and replace the internal storage devices perform the following:
A. To remove an internal storage devices from your Series 700 system refer to your Series 700
Owners Guide.
B. The hard disk jumper settings are shown in Figure 2, Figure 3, and Figure 4. Ensure the jumpers
on your disk drive are set to the appropriate configuration.
Front View
LED
J3
1 2 3 4 5 6 7 8 9 10
SCSI
ID
Second
Drive
5
Quantum Disk Drive Models – VP32210
SCSI
ID
Second
Drive
5
Hewlett-Packard Disk Drive Models – C3324A
Do not change
NOTICE:
0950–2606
HP Part Numbers – 0950–2601
C3325A
HP Part Number – 9164–0395
VP31110
DEC Disk Drive Model – DSP3107LS
any other jumpers
If applicable change the SCSI ID to 5 as shown
Figure 2. Internal Storage Device Jumper Settings
C. The CD ROM drive jumper settings are shown in Figure 5. Ensure the jumpers on your CD ROM
drive are set to the appropriate configuration.
D. To install the internal storage device(s) in your B–Class workstation, refer to Figure 6 and the
Model B132L/B160L Owner’s Guide (A4190–90014).
NOTICE:When using a hard disk from your Series 700 workstation, it cannot be config-
ured as the boot drive and must be installed in position 2 (front position).