Specifications

Coprocessor Console
6.3 Coprocessor Console Terminal Connection
3/96 Application Module
X
Service 87
Honeywell Inc.
.
Note: The cable connection to the U
X
S is different depending on if it is
Release 100 or 200 hardware. The U
X
S-100 connection is to the WSI I/O
board J2 (normally used for printer). The U
X
S-200 connection is to the
WSI2 I/O board J1 (normally used for U
X
S coprocessor console terminal).
The following table defines the different cable types available for
connecting coprocessor terminals.
4 Make sure the terminal is powered on.
5 If you are using a PC as the coprocessor console,
invoke the emulation software and configure it
for the following characteristics:
• 9600 bits/second
• 8 bits/character
• no parity
6 The procedure for using a VT-100 compatible
terminal (simple terminal, Personal Computer, HP
712/60 workstation, or U
X
S) as a coprocessor
console is provided in the Application Module
X
System Administration manual.
7 Establish communications using the terminal
keyboard.
8 The activities that require the coprocessor console
terminal are documented in the A
X
M System
Administration manual, Reference >> A
X
M Setup
(Section 2.3)
Table 6-1 Terminal Connection Procedure (continued)
Step Action
40040
WSI2 I/O
Coprocessor
WSI2
Terminal
Interface
Cable
VT-100
Compatible
Terminal
OR
HP 712/60
Work Station
Personal
Computer
U S
X
J1
RS-232
Port
Serial
Port
RS-232
Port
Serial
Port