Specifications

14 Application Module
X
Service 3/96
Honeywell Inc.
Hardware Description of LCN Node Processors
3.1 K2LCN-X Node Processor
Indicator
description
The following table gives a description of the indicators on the K2LCN
board. Reference the preceding diagram.
Table 3-1 K2LCN Board Indicators
LED Description Suspected cause if abnormal
Self-Test Pass On after board passes self-test.
Normally on.
K2LCN
TX On when transmitting on the
LCN. Normally on or flashing
rapidly.
K2LCN
RST/PWR fail On when a reset operation
caused by the reset button or
power on is in progress. Normally
off.
K2LCN
Self-Test Error On to indicate a board self-test
error. Normally off.
K2LCN
Data Compare Error On to indicate an on-board data
compare error. Normally off.
K2LCN
DTAK Time Out On to indicate a Data Transfer
Acknowledge failure. Normally
off.
K2LCN
BGAK Time Out On to indicate a Bus Grant
Acknowledge failure. Normally
off.
K2LCN or other board(s) in
chassis
Data Parity Error On to indicate an on-board data
parity error. Normally off.
K2LCN
Bus Error On to indicate a detected
backplane bus parity error.
Normally off.
K2LCN, other board(s) in chassis,
or backplane
EDAC Single-Bit Error On to indicate a single-bit
(correctable) RAM error. Normally
off.
K2LCN
EDAC Multiple-Bit Error On to indicate a multiple-bit
(uncorrectable) RAM error.
Normally off.
K2LCN
LCN Transaction Error On to indicate communication
problems with the LCN. Normally
off.
K2LCN or CLCN A/B I/O (LCN I/
O) or
LCN network
Node Address/Error display This 3-digit display normally
displays the pinned LCN node
address. It will display error
codes for further problem
definition in error situations.
See Five-Slot Service Manual for
multiple possible causes.
Reference >>Alpha Numeric
Displays in Appendix A.