Specifications

8 Application Module
X
Service 3/96
Honeywell Inc.
Application ModuleX Overview
2.3 Board Slot Definition
Ten-slot board
placement
The following two tables show the A
X
M board placement for the Ten-slot
chassis using the HMPU node processor. Two versions of board placement
are used depending on the size of the coprocessor memory which is located
on the WSI2 board. The 256 megabyte size requires additional space above
the WSI2 board.
Slots 7 through 10 do not share a common backplane for interconnection
with slots 1 through 6.
The Hard Drive Disk tray does not depend on the backplane for signal
interconnection with other slots. It only uses the slots it occupies to obtain
power, which is common to all slots.
* Two versions of the WSI2 board are available to provide the 64 MHz and
100 MHz coprocessors.
** Non-CE compliant versions use the LCN I/O.
Table 2-3 Ten-Slot Chassis Board Locations (with 32/64/128 MB
Coprocessor Memory sizes)
Slot Front Rear
10 Unusable slot
9 Unusable slot
8 Hard Disk Drive Tray
(occupies two slots)
7 HDDT I/O
6 WSI2 * WSI2 I/O
5 Optional Application board
4 Optional memory board
3 QMEM-2
2 LLCN CLCN A/B
or
LCN I/O **
1 HMPU