Specifications

114 Application Module
X
Service 3/96
Honeywell Inc.
CD-ROM Drive
10.3 CD-ROM Replacement
5 Remove the power connector from the rear of the
device.
6 Remove SCSI interface cable from the rear of the
device.
7 Remove the drive from its mounting hardware.
8 Check that the new drive pinning and SCSI
terminators are correct. Compare to the old drive, if
required. (Note that there is a difference with and
without the DAT drive.)
9 Install the new drive into its mounting in the station
removable media tray.
10 Connect the SCSI interface cable to the rear of the
drive (removed in Step 6).
11 Connect the power connector to the rear of the drive
(removed in Step 5).
12 Power on the A
X
M node power supply.
13 Allow sufficient time for the HP-UX software to boot
(yellow indicator on WSI2 board comes on).
14 Load the A
X
M node personality using the “Autoload
Net” target on the Node Status display.
15 The new CD-ROM drive is now ready for checkout
using normal HP-UX tools. Suggest using the tools
provided under the HP-UX “xstm” command.
Reference the Man Page online feature or HP-UX
documentation for additional information on the
“xstm” command.
Table 10-1 CD-ROM Replacement Procedure (continued)
Step Action