Specifications

110 Application Module
X
Service 3/96
Honeywell Inc.
CD-ROM Drive
10.2 CD-ROM Physical Configuration and Cabling
10.2 CD-ROM Physical Configuration and Cabling
CD-ROM pinning
(without DAT
drive)
The SCSI interface must be terminated by placing termination resistor
assemblies at the drive located at the end of the cable (farthest from HDDT
I/O board). The following illustration shows the proper pinning (device
address 2) and terminators for the CD-ROM when the configuration does
not include a DAT drive.
CD-ROM pinning
(with DAT drive)
The SCSI interface must be terminated by placing termination resistor
assemblies at the drive located at the end of the cable (farthest from HDDT
I/O board). The following illustration shows the proper pinning (device
address 2) and terminators for the CD-ROM when the configuration
includes
a DAT drive.
SCSI Address 2 and Termination
Jumpers Installed
(Use 51190624-900
If Needed)
Termination Resistors
Installed (Use 51192039-122)
51894
51893
SCSI Address 2 and No Termination
Jumpers
Installed
Termination
Resistors
Removed