Specifications

DAT DRIVE
9.3 DAT Drive Physical Configuration and Cabling
3/96 Application Module
X
Service 103
Honeywell Inc.
DAT SCSI interface
termination
The termination for the coprocessor SCSI bus must be provided by the
device at the end of the cable when external peripherals are connected to
the coprocessor. The DAT drive will always be at the end of the SCSI cable
if a DAT exists.
The terminator assemblies that provide this function within the DAT drive
are mounted immediately above the SCSI interface cable connection. See
the identified terminator assemblies on the following diagram.
A power jumper at the bottom right is required to provide power for the
terminator assemblies. See the terminator power jumper in the diagram.
These SCSI interface terminators and power jumper must be checked, and
added if necessary, when installing a DAT drive as a new option or a
replacement drive.
40050
Option Switches Located
on Bottom
ON
12345678
(All Switches On)
Terminators
(Plugged in Behind Ribbon Connector)
PWR
SCSI 2 SCSI 1 SCSI 0
NC
Power Harness
to 5-Slot
Backplane (J9)
51304836-100
Terminator
Power Jumper
51196257-100
51304837-100
Jumper
Sets
Address=1
TERM