Specifications

94 Application Module
X
Service 3/96
Honeywell Inc.
TAC Access to Coprocessor
7.3 Modem Connection
Modem
connection
procedure for U.S.
Robotics Sportster
9600
C A UTION
The modem can be connected while power is applied to the
A
X
M and the modem. Proper care should be exercised to
ensure the cable ends do not come in contact with other
electrically charged components.
Table 7-3 Modem Connection Procedure
Step Action
1 Make sure the modem is properly configured
(switches and internal configuration registers).
2 Connect one end of the modem interface cable to the
modem.
3 Connect the other end of the modem interface cable
to the WSI2 I/O board for serial Serial Port 1
(connector J1).
You will have to disconnect the coprocessor console
terminal cable from this jack if the terminal is
currently connected.
4 Make sure the telephone connection to the modem is
properly made.
Frame Ground
Transmitted Data
Received Data
Request to Send
Clear to Send
Data Set Ready
Signal Ground
Data Carrier Detect
Data Terminal Ready
Transmitted Data
Received Data
Ground
D-9 Female
D-25 Male
Modem
Connector
40043
U S Connector
(WSI2 I/O J1)
X
1
2
3
4
5
6
7
8
20
1
2
3
4
5
6
7
8
9