Technical data

Getting Started with PowerPC Open Firmware 57
Make your selection by entering either A or B.
Note Because MVME2600/3600 Series products provide two
distinct flash memory banks, selection of a bank is
required.
7. Enter Y and press <ENTER> to proceed with the
replacement. A search for the file oemlogo.bmp is
performed. When the file is found, the following prompt is
displayed:
Update the OEM Bitmap Logo in ROM Using This File? (Y/N)
8. If no floppy disk is present or if a floppy drive is not attached
the following prompt is displayed and the bitmap update
process is terminated.
No Floppy Drive and/or Disk Found
Press <ESC> to return to the Update the Firmware menu.
9. Enter Y to store the new image into ROM. During this process
the following is displayed:
Loading Image Into ROM ...
Erasing ...
Programming ...
Verifying ...
Once the ROM is updated the following prompt is displayed:
New Logo Added
Set mot-oem-logo? Flag (This Will Enable New Logo)?
(Y/N)
10. Enter Y and press <ENTER> to enable the new bitmap logo.
11. Enter N and press <ENTER> to select the default Motorola
logo.