Setup guide

4 Release Notes

Supported Pro Tools Hardware and Software Part 0130-04819-01 Rev. A

Supported Pro Tools Hardware and Software

Digidesign offers a range of Pro Tools products for both Macintosh

operating system and the Windows NT operating system.

At present, only Digidesign’s Pro Tools|24 MIX workstations are

supported in a MediaNet workgroup. These workstations must be

Macintosh-based, and running the Pro Tools v5.1U software and the

MediaNet for Pro Tools Release 1.2.2 client software.

The following sections describe the Pro Tools hardware and software

required to connect a Pro Tools workstation to a MediaNet

workgroup.

Supported Digidesign Hardware

MediaNet for Pro Tools supports the following Digidesign hardware:

• Pro Tools|MIX hardware (required)

• Universal Slave Driver (required)

• Digidesign 888|24, 882|20, 888, 882, and ADAT Bridge audio

interfaces only (optional, qualified)

• AVoption|XL (optional, qualified)

• ProControl (optional, qualified)

• Digidesign SCSI-64 board for local storage (optional, qualified)

If you are using both local storage and MediaNet storage, you should keep all

of the files for your session in one location or the other. Splitting sessions

across both storage mediums is not recommended. See “32 Voice Playback

Engine” on page 26 for additional information.