Technical data

U26140-J-Z146-3-76 67
4 mm Autoloader Status and error messages
8.5.2 Additional information messages
In addition to the messages listed above, the LCD shows the following infor-
mation messages:
Message Meaning
C1553A Product identifier. It is displayed for 2 seconds during power-
up.
ForceEject A forced eject is in progress (see the section “Forcing
ejection” on page 62). The message finishes when the
magazine is ejected.
SCSI ID: x x is the SCSI address of the autoloader. It is displayed for 2
seconds following the product identifier.
Config: xxx xxx is the value of the configuration switches. It is displayed
for 2 seconds following the SCSI ID.
Stray Tape:
Insert Empty
Mag
A cartridge is present in the autoloader, but there is no
magazine present. Insert an empty magazine to retrieve the
cartridge.
Select Tape This is displayed when the Select button is pressed, and for
a short time after the button is released.
Load Tape This is displayed when the Load Tape button is pressed.
Eject Mag This is displayed when the Eject button is pressed.