Technical data

64 U26140-J-Z146-3-76
Status and error messages 4 mm Autoloader
8.5 Status and error messages
This chapter discusses the status and errors messages displayed on the LCD
(see figure 26 on page 57).
8.5.1 Functional fields of the autoloader
The status messages that appear on the LCD cover five functional fields of the
autoloader operation.
The following table shows the status messages in each functional field and
indicates how control of the LCD passes to the next field. The messages in
brackets are not displayed on the LCD as control has already passed to the next
functional field.
Functional field Message Meaning
Reset Self Test The autoloader is performing its power-on
self-test.
(Test O.K.)
Firmware
upgrade state
FW Upgrade Firmware upgrade data is being read either
through a tape or the SCSI bus.
FW Check Firmware upgrade data is being checked for
compatibility.
FW Program The embedded MTC drive is being
upgraded with the new firmware.
New FW!!!! The firmware upgrade process has been
successfully completed.
(No Upgrade)
Magazine load
state
Insert Mag The autoloader is ready to accept a
magazine.
Mag Check The autoloader is examining the magazine
to find which slots are occupied.
Mag Eject The autoloader is ejecting the magazine
(Mag
Loaded)