Technical data

U26140-J-Z146-3-76 37
8 mm MTC drives Technical data
5.3.4 LCD
The LCD displays reset messages, status information and drive errors.
The following reset messages appear in sequence when the system unit in
which the drive is installed is switched on:
I These messages are for information purposes only and do not require
any action by the user.
Reset messages Meaning
RESET Basic drive setting
(message appears when system unit is switched
on or the SCSI bus is reset)
MODEL Drive model name
SUBMOD Drive software configuration
(combination of letters and digits)
SN: Drive serial number
(combination of letters and digits)
CODE: Drive firmware version
(combination of letters and digits)
LAST CLEAN The operating time (tape activity) since the last
cleaning: e.g. 1.1 HRS
COMPRESS ON Data compression is on or
COMPRESS OFF Data compression is off
SINGLE-ENDED Drive connected to system via single-ended SCSI
port (i.e. 8 bit data transfer) or
DIFFERENTIAL Drive connected to system via differential SCSI
port (i.e. 16 bit data transfer)
WIDE Drive has a WIDE-SCSI port (16 bits), higher data
transmission rate than NARROW-SCSI or
NARROW Drive has a NARROW-SCSI port (8 bits)
SCSI-ID Drive identification on the SCSI controller